GRAPHTEC LABELROBO LCX603 - Page 63

2-31
Chapter 2 Preparation for Printing
(9) Set the ribbon cassette in the ribbon stocker.
• Push the ribbon cassette all the way to the back of the ribbon stocker and make sure it doesn't
come back.
• Carefully set the up/down direction.
• Make sure the ink ribbon is not slack. Roll up the ribbon if it is slack.
• Make sure there are no wrinkles in the ink ribbon. Missing text occurs when there are wrinkles.
• Always set a black ribbon for ribbon 3 (Head 3).
• Set non-black ribbons in ribbon 1 (Head 1) and ribbon 2 (Head 2)
Set other ink ribbons in the same manner.
(10) Push the lever and
slowly and quietly return the ribbon stocker to the main body. Push until there is a clicking
sound. Push and fasten the lever so that it is secured in the slot, and close the ribbon stocker cover.
Insert the ribbon stocker deep into the main body.
• Insert the ribbon stoker deep into the main body.
• Make sure the lever's bulge is fastened in the slot.
4UFQ
4UFQ
4UFQ
-FWFS
$MJDL
3JCCPOTUPLFSDPWFS
'BTUFOUIFMFWFShTCVMHF
JOUIFTMPU