v
Safety Precautions
When using indoor lighting such as fluorescent
lamps and desk lamps, make sure the label printer is
separated by at least 1 m.
• Placing the label printer too close to such lighting may
cause sensor malfunctions and the paper detection to not
function efficiently.
Safety Precautions
Run a test cut when cutting materials with unknown
condition settings.
• Running a cut operation with incorrect setting values may
cause a large overload to the blades and device or a
system breakdown.
Move the pen carriage slowly when moving it manually
in order to load the medium or for other reasons.
• Moving it quickly may damage the label printer
Before use, check that the power is turned off by
pressing the Emergency Stop Switch.
To Next Page
Loading...
