2-40
Chapter 2 Preparation for Printing
2.11 Using the Laminate
Once the label materials are set, set the laminate section.
• Set the laminate function when the label materials have been set.
• Refer to "2.6 Loading Label Materials (media)" regarding setting label materials.
• Prior to using the laminate function, refer to "2.9 Adjusting the Function Setting", and then turn the
"laminate" on.
• Refer to "2.10 Using the Separator" regarding the separator.
• The degree of accuracy can be affected when the laminate material glue attaches to the push roller.
Regularly clean the push roller.
• The shape of the media stocker flange resembles the laminate stocker flange. The object with the
long shaft is the laminate stocker flange.
• The shape of the separator winder bobbin is similar to the laminate winder bobbin. The section
with the small gears attached to shaft is the laminate winder bobbin.
• Even when the laminate settings are off, exercise caution as a laminate error can occur when the
laminate section is rotated by hand.
<Steps For When Using Laminate>
Step
Present Condition
Turn the power ON
(READY Status)
Set label
materials
Turn on separator
settings
Set the laminate
section
Power ON (READY Status)
Finished setting label materials
— — Step 1 Step 2
Power ON (READY Status)
Not finished setting label materials
— Step 1 Step 2 Step 3
Power OFF
Finished setting label materials
Step 1
— Step 2 Step 3
Power OFF
Not finished setting label materials
Step 1 Step 2 Step 3 Step 4
●Reference
[Turn power ON]: Refer to "2.4 Connecting to the Power Supply".
[Setting label materials]: Refer to
"
2.5 Setting Label Materials (media)", "2.6 Loading Label Materials (media)".
[Turn on laminate setting]: Refer to the latter "Turning On the Laminate" section.
[Set in the laminate section]: Refer to the latter "Setting the Laminate" section.
<Media Route>
'FFESPMMFS
-BNJOBUFCBS
0VUMFU
1SFTTSPMMFS
$VUUFSVOJU
.FEJBTUPDLFS
-BNJOBUFTUPDLFS
4FQBSBUPSXJOEFSCPCCJO
%BODFSSPMMFS %BODFSSPMMFS
To Next Page
Loading...
