GRAPHTEC LABELROBO LCX603 - Page 79

2-47
Chapter 2 Preparation for Printing
2.13 Selecting Tool Conditions
Adjust settings for "Tool Conditions", "Tool", "Offset", "Fource", "Speed", and "Acceleration".
LCD Display
'
'
'
'
< 1 0 9 U + 1 1 4 3 0 2 >
[ T O O L T Y P E ]
S E L E C T : ← → ↑ ↓
Y E S : E N T E R N O : E S C
"O@VOEFSCBSJTTIPXOVOEFSOFBUI
UIFTFMFDUFEUPPMDPOEJUJPO
5PPM 'PSDF
"DDFMFSBUJPO
500-$0/%*5*0/4 0GGTFU
4QFFE
4FMFDUFEUPPMDPOEJUJPO
4FMFDUFE
UPPMDPOEJUJPOOBNF
Selecting Tool Conditions
Tool Condition can memorize 8 settings from 1 to 8. In addition, based on switching between these settings, it is
possible to switch between 8 different types of label material settings that are programmed beforehand.
(1) Press the TOOL COND. key from the READY status and the below message will display.
'
'
'
'
T O O L C O N D I T I O N S >
T E S T C U T >
C U T T I N G W I D T H >
(2) Press the F1 key (TOOL CONDITIONS), and the below message will display.
'
'
'
'
< 1 0 9 U + 1 1 4 3 0 2 >
[ C O N D I T I O N N O . ]
S E L E C T : ← → ↑ ↓
Y E S : E N T E R N O : E S C
(3) Press the POSITION keys (
▲▼
) to change the tool conditions.
The settable range is 1-8.
(4) If the programmed content is acceptable, press the ENTER key.
If you press the LOCAL key before again pressing the ENTER key, the condition settings will clear without applying
the condition settings.