GRAPHTEC LABELROBO LCX603 - Page 82

2-50
Chapter 2 Preparation for Printing
Setting Speed
The speed setting adjusts the tool speed during cutting. Program tool conditions by label material type and tool type as
the standard. (Refer to the previous "Tool Conditions by Tool Type".)
(Setting range: 1 - 10 (every 1 cm/s), 10 - 30 (every 5 cm/s))
(1) Press the TOOL COND. key from the READY status and the below message will display.
'
'
'
'
T O O L C O N D I T I O N S >
T E S T C U T >
C U T T I N G W I D T H >
(2) Press the F1 key (TOOL CONDITIONS), and the below message will display.
'
'
'
'
< 1 0 9 U + 1 1 4 3 0 2 >
[ C O N D I T I O N N O . ]
S E L E C T : ← → ↑ ↓
Y E S : E N T E R N O : E S C
*The displayed content will vary depending on the selected tool condition setting area.
(3) Press the POSITION keys (
◄►
) to go to speed setting.
'
'
'
'
< 1 0 9 U + 1 1 4 3 0 2 >
[ S P E E D ]
S E L E C T : ← → ↑ ↓
Y E S : E N T E R N O : E S C
(4) Press the POSITION keys (
▲▼
) to change speed.
Setting range is 1 - 10 (1-step) · 15 · · (5-step) · · 30 (cm/s).
(5) If the programmed content is acceptable, press the ENTER key.
If you press the LOCAL key before again pressing the ENTER key, the condition settings mode will be cleared.
Setting Acceleration
Acceleration during cutting adjusts the quality. Program tool conditions by label material type and tool type as the
standard. (Refer to the previous "Tool Conditions by Tool Type".)
(Setting range: 1 - 3)
(1) Press the TOOL COND. key from the READY status and the below message will display.
'
'
'
'
T O O L C O N D I T I O N S >
T E S T C U T >
C U T T I N G W I D T H >
(2) Press the F1 key (TOOL CONDITIONS), and the below message will display.
'
'
'
'
< 1 0 9 U + 1 1 4 3 0 2 >
[ C O N D I T I O N N O . ]
S E L E C T : ← → ↑ ↓
Y E S : E N T E R N O : E S C
*The displayed content will vary depending on the selected tool condition setting area.
(3) Press the POSITION keys (
◄►
) to go to acceleration setting.
'
'
'
'
< 1 0 9 U + 1 1 4 3 0 2 >
[ A C C E L ]
S E L E C T : ← → ↑ ↓
Y E S : E N T E R N O : E S C
(4) Press the POSITION keys (
▲▼
) to change acceleration.
(5) Press the ENTER key and the below message will display.
The settable range is 1 - 3. The lowest setting will reduce acceleration and increase quality.
(6) If the programmed content is acceptable, press the ENTER key.
If you press the LOCAL key before again pressing the ENTER key, the condition settings mode will be cleared.