3-12
Chapter 3 Printer Driver
[Options] Tab
When you click on the [Options] tab, the following screen appears.
Resolution ......................Select the resolution for data output from either 600 dpi × 600 dpi or 600 dpi × 1200 dpi.
Typically, please use 600 dpi × 600 dpi.
When switching resolution from the driver software (600 × 600 dpi
←→
600 × 1200 dpi), if there
is data currently being output, perform the switch once all data has been output. Please use
caution, since changing the resolution during data output consumes non-print media.
Transfer Data Type .........Specify the type of data to be transferred from either PCX or RAW.
Typically, please use PCX.
Dithering ........................"None", "Coarse" or "Fine" can be selected.
Typically, use "None".
Restore Defaults ............Resets the settings to their original values.
To Next Page
Loading...
