GRAPHTEC LABERLROBO DLC1000 - Page 108

3-4
Select each of the following tabs and make settings.
>3DSHU@WDE8VHGWRVHW0HGLDZLGWK3DJHVL]H/D\RXW2ULHQWDWLRQ8QLWRIOHQJWKDQG1XPEHURISULQWFRSLHV
,Q>&XW2SWLRQ@WDEVHWWKH&XW/LQHHWF
&OLFN>3ULQW@DQGRSHQWKHZLQGRZ
[Paper] Tab
:KHQ\RXFOLFN>3DSHU@WDEWKHIROORZLQJVFUHHQDSSHDUV
Media Width ................ Set the width of roll paper to be set in this machine.
In the CUSTOM, a free width can be registered.
3DJH6L]H .................... 6HWWKHSDJHVL]HRIWKHGULYHULQRUGHUWRGHWHUPLQHWKHSDSHUVL]HRQWKHDSSOLFDWLRQ
when creating the label data.
7KHUHDUHWKHIROORZLQJW\SHVRIVHOHFWDEOHSDJHVL]HV
“A5”, “A6”, “A7”
“4in x 3in”, “4in x 6in”, “6in x 4in”, “6in x 8in”
´8VHUGHÀQDEOHVL]HWRµ
:KHQWKHSDJHVL]HLVGHÀQHG\RXFDQUHJLVWHUDIUHHVL]HE\FKDQJLQJWKHGHÀQLWLRQ
name.
7KHPD[LPXPVL]HLV[PP
Mirror ........................... Used to cut the media after the label is mirror-reversed.
Rotated ........................ Set one of OFF, 90-degree, 180-degree, or 270-degree.
Scaling ......................... Set the scaling ratio of the data to be cut.
Orientation ................... Set the orientation to either “landscape” or “portrait”.
Unit ............................. Change the unit used to display on the screen.
About ........................... Click to display the copyright and version information of the driver software currently in
use.
Restore Defaults .......... Restores the set value to the initial value.
* The minimum size of the media feed direction of the DLC1000 main unit is 76.2 mm.
Even if a value lower than 76.2 mm is set, the output will be 76.2 mm.