GRAPHTEC LABERLROBO DLC1000 - 4.7 Setting Registration Marks (Number of Points)

4-10
4.8
NUMBER OF POINTS
Set the number of registration marks from the “NUMBER OF POINT”.
The number of registration marks that has been set is loaded to the cutter unit and the media is cut in
accordance with the registration marks.
Select the axis adjustment (inclination adjustment) from “1POINT”, “3POINT” or “OFF”.
To perform the axis adjustment (inclination adjustment) and distance adjustment, use as follows.
1POINT ....................... For 1-point adjustment, the axis is adjusted, based on the position of data start point (origin
point).
3POINT ....................... For 3POINT adjustment, the axis is adjusted, based on the three registration marks of
the origin, X-axis direction, and Y-axis direction.
OFF ............................ The Axis is adjusted, based on the position of data start point (origin point) (This is high-
speed version of the 1POINT). Operating time is shorter, however the position error may
be greater than the 1POINT.
Push roller
Media feeding direction
Registration Mark 3
Registration Mark 1Registration Mark 2
Operation
1
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
2
Press the POSITION ( ) keys to select “CHANGE
6(77,1*6µ7KHLWHPLVKLJKOLJKWHG7KHQSUHVV>(17(5@
key.
CHANGE SETTINGS screen is displayed.