GRAPHTEC LABERLROBO DLC1000 - Removing the Tool

2-5
CAUTIO
When pushing up the tool holder with your
ÀQJHUVWKHFXWWHUEODGHWLSPD\EHSURWUXGLQJ
7DNHFDUHQRWWRFXW\RXUÀQJHUV
2
:KLOHSXVKLQJXSWKHWRROKROGHUSXVKXQWLOLWVÁDQJH
completely touches the upper part of the holder.
Cutter plunger can not
to be set in forward.
Set on the tool
holder (Backward).
Tool holder
Tool holder
Flange
Bracket to hold tool
3
Make sure that the tool bracket is engaged on the tool's
ÁDQJHDQGWKHQWLJKWHQWKHVFUHZ
Flange
Bracket to hold tool
Removing the tool
When removing the tool, turn it counterclockwise to remove the tool.