GRAPHTEC LABERLROBO DLC1000 - Setting the Length of Overcuts (OVERCUT)

2-68
Setting the Length of Overcuts (OVERCUT)
Set the TANGENTIAL MODE to ON or OFF individually for each tool condition no. of 1 to 8.
When setting the length of overcut, the start and end of the overcut length should be set.
(Refer to “Outline of Tangential Emulation (TANGENTIAL MODE)” described below.)
Setting range: 0.0 to 0.9 mm
Operation
1
3UHVVWKH>&21'7(67@NH\LQ5($'<VWDWXV
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION ( ) keys to select the TANGENTIAL
MODE (The selected item is highlighted.). Then, press
>(17(5@NH\
Cond No. selection screen is displayed.
3
Press the POSITION ( ) keys to select the OVERCUT
START.
Supplement
Settable range is 0.0 to 0.9 mm.
4
Press the POSITION ( ) keys to increase or decrease the
setting value.
5
Press the POSITION ( ) keys to select the OVERCUT
END.