GRAPHTEC LABERLROBO DLC1000 - 2.5 Setting Label Material (Media)

2-11
2.5
Setting the Label Material (Media)
Supplement
Please wipe out the dust and dirt lightly from a label or laminate material by using a dry cleaning paper or clean paper.
6HWWDEOHVL]HRIWKHODEHOPDWHULDOLVDVIROORZV
• Width: max. 216 mm, min. 100 mm
• Outer diameter: 254 mm, 200 m roll
6HWWDEOHVL]HRIWKHlaminate material is as follows.
For the laminate material, use the narrow width of 20 mm than the label material.
• Width: max. 196 mm, min. 80 mm
• Outer diameter: 210 mm or 200 m roll
For the relationship of the label material and the laminate material, and FXWWLQJDUHDUHIHUWRWKHÀJXUHEHORZ
<Cutting area>
• Label material (media) width: 70 to 186 mm (It depends on the media width to be used.)
• Label material (media) feeding direction: 76.2 to 300 mm
Feeding direction
* Unit: mm
Label material width = W
Cut width
= W - 301861510
15
10 /DEHOPDWHULDOZLGWK : 10
Material clip area
15
Material clip area
Label Material (Media) Type
There are two types of involute and revolute on the label material. Please use the revolute on the label material in
this machine.
InvoluteRevolute
NGOK
Printing surface
Printing surface