GRAPHTEC LABERLROBO DLC1000 - When Using the Media after Printing in DLP1000

2-16
When Using the Media After Printing in DLP1000
Prepare to set the media and roll holder after printing in DLP1000.
1
Align the position of the roll holder.
/RRVHQE\WXUQLQJWKHÁDQJHÀ[LQJVFUHZVWLPHV
3OHDVHGRQRWORRVHQWKHÁDQJHÀ[LQJVFUHZVWRRPXFK7KHSLQZLOOQRORQJHUKLWLQ6WHS
Flange A
)ODQJHÀ[LQJVFUHZ
2
Move the label material (media) to the direction of the pin in a state which the Flange A and the media
KDYHEHHQÀ[HG
Move the label material (media) until it contacts the pin.
/RRVHWKHÁDQJHÀ[LQJVFUHZ
Media
Flange A
Pin
Flange A
Media
)ODQJHÀ[LQJVFUHZ