GRAPHTEC LABERLROBO DLC1000 - 4.9 Sensor Offset Adjustment

4-14
4.10
SENSOR OFFSET ADJUST
Adjust the position of the registration mark sensor from the SENSOR OFFSET ADJUST.
Usually, set the setting values of both X and Y to “0.0”.
You can adjust the cut position if the cut position is shifted always in the same direction.
Operation
1
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
2
Press the POSITION ( ) keys to select “CHANGE
6(77,1*6µ7KHLWHPLVKLJKOLJKWHG7KHQSUHVV>(17(5@
key.
CHANGE SETTINGS screen is displayed.
3
Press the POSITION ( ) keys to select “MARK”. Then,
SUHVV>(17(5@NH\
MARK screen is displayed.
4
Press the POSITION ( ) keys to select “SENSOR OFFSET
$'-867µ7KHQSUHVV>(17(5@NH\
SENSOR OFFSET ADJUST screen is displayed.