GRAPHTEC LABERLROBO DLC1000 - Page 125

4-15
6
3UHVV>(6&@NH\12WRGLVSOD\WKHDGMXVWPHQWYDOXH
setting menu without cutting with adjustment patterns. (The
screen goes to “Numerical entry of registration mark position
adjustment”).
:KHQ>(17(5@NH\LVSUHVVHGWKHUHJLVWUDWLRQPDUNRIRULJLQ
position (Registration Mark 1) is sensed and the media is cut
WRFRQÀUPLW[PPIURPWKHRULJLQSRVLWLRQ
Push roller
Media feeding direction
Registration Mark 1
&XWWRFRQÀUP
(20×20mm)
Check this cut position (deviation volume) and then go to
“Numerical entry of registration mark position adjustment”.
Numerical entry of registration mark position adjustment
Push roller
Media feeding direction
Registration Mark 1
Correct rectangle position
(Dashed line)
Actual cut
(Solid line)
7
Perform the numerical entry of registration mark position
adjustment.
SENSOR OFFSET ADJUST screen is displayed.
The range of X and Y are -3.0 to +3.0 mm.
When the inch unit is used, adjust the position of registration
mark sensor by setting both X and Y to the range of -0.118 to
0.118 inches.