GRAPHTEC LABERLROBO DLC1000 - 4.13 Offset Force Adjustment

4-24
4.14
OFFSET FORCE
Set the offset force from the “OFFSET FORCE”.
To confirm the blade direction at the time of initial operation, set the offset force of the initial blade control.
The initial value is set to "4". If the number is larger, the cutting pressure will be higher.
To point the blade tip to the correct cut direction, perform the cutting operation only slightly before cutting. In
this case, set the lower cutting pressure than usual as OFFSET FORCE because that high cutting pressure is not
required.
Setting range: 1 to 31
Operation
1
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
2
Press the POSITION ( ) keys to select “CHANGE
6(77,1*6µ7KHLWHPLVKLJKOLJKWHG7KHQSUHVV>(17(5@NH\
CHANGE SETTINGS screen is displayed.
3
Press the POSITION ( ) keys to select “OFSET FORCE”.
7KHQSUHVV>(17(5@NH\
OFFSET FORCE screen is displayed.
Supplement
Settable range is 1 to 31.
4
Press the POSITION ( ) keys to increase or decrease the
setting value.
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
Setting will be set, and it will return to CHANGE SETTINGS.
6
3UHVVWKH>0(18@NH\
It will return to READY screen.