GRAPHTEC LABERLROBO DLC1000 - 4.4 Copy and Feed Operations

4-6
4.5
COPY / ENDING FEED
The designated number of copies of newest incoming data in memory is reproduced.
The designated number can be copied from 0001 to 9999.
When the copy operation is enabled, you can set the Ending Feed.
Operation
1
Try to cut once the data you want to cut.
(The cut data is stored in the buffer.)
2
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
Supplement
When there is no data to be output, the following
is displayed.
3UHVVLQJ>(6&@NH\5(7851UHWXUQVWR
previous screen.
3
Press the POSITION ( ) keys to select “COPY” (The item
LVKLJKOLJKWHG7KHQSUHVV>(17(5@NH\
COPY screen is displayed.
Supplement
Pressing the POSITION ( ) key from "0001"
allows you to set the "Ending Feed".
4
With the POSITION keys ( ), select the digit you want
to enter, then with the POSITION keys (
), change the
number (0 to 9), and set the number of copies.
Execute the COPY with the ENTER key.
Press the ESC key to return to the previous screen.
,I\RXZDQWWRVWRSLQWKHPLGGOHRIWKHFRS\SUHVV>(6&@NH\
After a while, it returns to the READY screen.