GRAPHTEC LABERLROBO DLC1000 - Setting the Tangential Emulation (TANGENTIAL MODE)

2-67
Setting the Tangential Emulation (TANGENTIAL MODE)
The Tangential Emulation (TANGENTIAL MODE) is to adjust the blade when cutting.
Set the TANGENTIAL MODE to ON or OFF individually for each tool condition no. 1 to 8.
(Refer to “Outline of Tangential Emulation (TANGENTIAL MODE)” described below.)
Setting range: OFF, MODE1, and MODE2.
Operation
1
3UHVVWKH>&21'7(67@NH\LQ5($'<VWDWXV
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION ( ) keys to select the CUT
CONDITION (The selected item is highlighted.). Then, press
>(17(5@NH\
Cond No. selection screen is displayed.
3
Press the POSITION ( ) keys to select the TANGENTIAL
MODE.
4
Press the POSITION ( ) keys to set the TANGENTIAL
MODE to “OFF”, “MODE1”, or “MODE2”.
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
Setting will be set, and it will return to CUT CONDITION & TEST screen.
6
3UHVVWKH>(6&@NH\
It will return to READY screen.