GRAPHTEC LABERLROBO DLC1000 - 2.2 Attaching and Removing Tools

2-4
2.2
Attaching a Tool
Attach a tool (cutter plunger) to the machine.
Attaching a Tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its flange contacts the upper part of the holder and then tighten
the screw firmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting machine is turned on or
whenever the tool is moving.
•
There are two types of tool holders. When setting the cutter plunger in the tool holder, please be careful to the
set position.
It is explained here using cutter plunger as an example.
Tool holder
Bracket to hold tool
Top Top
Cutter plunger can not
to be set in forward.
Set on the tool
holder (Backward).
Tool holder
CAUTION
:KHQSXVKLQJWKHWRROKROGHUZLWK\RXUÀQJHUVWKHEODGHWLSPD\EHSURWUXGLQJ7DNHFDUHQRWWRFXW\RXUÀQJHUV
Mounting
1
Loosen the tool holder screw.
Tool holder
Bracket to hold tool
Bracket to hold tool
Tool holder
Top Top