GRAPHTEC LABERLROBO DLC1000 - Emergency Stop Switch

1-5
Emergency Stop Switch
RESET
Only use this in case of emergency or check before use.
Pressing the switch will cause the switch to become depressed.
In this state, turning the power switch to the On position ( | ) will not turn the power on.
Cautionary notes for turning power on again
%HVXUHWRFRQÀUPWKDWWKHSRZHUVZLWFKLVLQWKH2II
) position.
When the power switch is in the Off position, you can turn it On by turning the emergency stop switch clockwise
until you hear the click and the switch pops up.
(1)
(2)
$IWHUFRQÀUPLQJVDIHW\WXUQWKHSRZHUVZLWFKWRWKH2Q_SRVLWLRQ
CAUTION
•
 :KHQWXUQLQJWKHSRZHURQIRUWKHÀUVWWLPHDIWHULPSOHPHQWLQJWKHHPHUJHQF\VWRSVZLWFKSXVKWKHVZLWFKWRWKH2QSRVLWLRQ
strongly.