GRAPHTEC LABERLROBO DLC1000 - Set the Label Material (Media)

2-12
Set the Label Material (Media)
Supplement
•
Since the roll holder is heavy, please be careful not to fall.
•
:KHQ\RXUHPRYHWKHÁDQJHSOHDVHEHVXUHWRXVHERWKKDQGV
•
7KHÁDQJHFDQQRWEHUHPRYHGLQDVWDWHLQZKLFKWKHUROHKROGHULVLQVWDOOHGWRWKHPDFKLQH
•
7KHVKDSHRIUROOKROGHUÁDQJHLVVLPLODUWRWKRVHRIODPLQDWHKROGHUÁDQJH7KHÁDQJHZLWKORQJHUVKDIWLVWKHUROOKROGHUÁDQJH
•
The shape of roll holder shaft is similar to those of laminate holder shaft. Longer shaft is the roll holder shaft.
•
:KHQWKHÁDQJHÀ[LQJVFUHZLVQRWWLJKWHQHGÀUPO\WKHUROOKROGHUVKDIWPD\EHIDOOHQ
•
When using the roll holder that media has been loaded after printing in the DLP1000, refer to “Use the Media After Printing in
DLP1000” described below.
1
Open the roll stocker cover of this machine and remove the roll holder from the roll stocker.
Roll holder
Roll stoker cover