GRAPHTEC LABERLROBO DLC1000 - 4.10 Paper Weight Setting

4-17
4.11
PAPER-WEIGHT
Set the paper restrain from the “PAPER-WEIGHT”.
Usually, set to “ON”.
Due to the media to be sensed and the registration mark printing state, the machine may fail to sense the
registration mark. In such the case, “OFF” should be changed to “ON”. By doing so, the sensing performance of
the registration mark will be improved.
When you do not want to use the PAPER-WEIGHT depending on the conditions such as the media to be sensed
and the registration mark printing state, set to “OFF”.
The paper weight is located at the bottom of the tool carriage (Invisible from the outside).
Operation
1
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
2
Press the POSITION ( ) keys to select “CHANGE
6(77,1*6µ7KHLWHPLVKLJKOLJKWHG7KHQSUHVV>(17(5@
key.
CHANGE SETTINGS screen is displayed.
3
Press the POSITION ( ) keys to select “MARK”. Then,
SUHVV>(17(5@NH\
MARK screen is displayed.
4
Press the POSITION ( ) keys to select “PAPER-WEIGHT”.
7KHQSUHVV>(17(5@NH\
PAPER-WEIGHT screen is displayed.