GRAPHTEC LABERLROBO DLC1000 - Page 126

4-16
CAUTION
•
Do not use for other than the registration mark
position adjustment. When a value is set to
anything other than adjustment purposes, the
registration mark sensing error will occur.
•
Since some error occurs in the sensing of the
registration mark, 0.2 mm or less value may
QRWEHUHÁHFWHGLQWKHFXWSRVLWLRQ
8
When actual cut position is shifted as shown with rectangle
6ROLGOLQHLQWKHÀJXUHVHW;YDOXHWRQHJDWLYHYDOXHDQG
set Y value to positive (+) value as deviation amount to move
(adjust) the rectangle to the correct position (Dashed line).
Supplement
Settable range is -3.0 to +3.0 mm.
9
Press the POSITION ( ) keys to increase or decrease the
X value.
10
Press the POSITION ( ) keys to select “Y”.
Supplement
Settable range is -3.0 to +3.0 mm.
Press the POSITION ( ) keys to increase or decrease the
Y value.
11
 &RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
Setting will be set, and it will return to MARK.
12
 3UHVVWKH>0(18@NH\
It will return to READY screen.