2-1
Chapter 2 Preparing
This chapter provides how to prepare before the operation.
PRODUCT SUMMARY
2.1 Preparation of Cutter Plunger
2.2 Attaching a Tool
2.3 Using the Control Panel
2.4 Turning on the Power
2.5 Setting the Label Material (Media)
<When using the separator (weeding)>
<When the winding roll holder is used>
<When the winding roll holder is not used>
2.6 Aligning the Push Rollers
2.7 Using the Laminate
2.8 Using the Cross Cutter
2.9 Using the Slitter
2.10 COND/TEST Key
2.11 Select the Tool Conditions
2.12 Adjusting the Blade Length
2.13 Running Cutting Tests
2.14 Stop during operation
2.15 Display Cutting Area
To Next Page
Loading...
