GRAPHTEC LABERLROBO DLC1000 - 2.3 Control Panel Operations

2-6
2.3
Using the Control Panel
The functions of the control panel lamps and keys are explained.
Screen (LCD) POSITION
(
, , , ) Key
COND/TEST Key ENTER Key
MENU KeyREADY Lamp DATA Lamp ESC Key
Indicator Lamps
READY Lamp ............. The READY lamp (Green) lights while the label printer is on.
If the MENU key is pressed, the green lamp goes off when the menu screen appears.
DATA Lamp ................. 7KH'$7$ODPS2UDQJHÁDVKHVZKHQWKHODEHOSULQWHUUHFHLYHVGDWD
The DATA lamp (Orange) lights while the data is stored in the internal memory.
The DATA lamp (Orange) goes out when the data is cleared (there is no data).
Panel Keys
MENU ......................... Switch from/to the REDY screen to/from the MENU screen.
COND/TEST ............... Switch the READY screen to the CUT CONDITION & TEST screen with the cutting
conditions and test menus.
(Cross Cut)
.............. &URVVFXWWKHPHGLDLQWKH5($'<VFUHHQ7KHFRQÀUPDWLRQVFUHHQLVGLVSOD\HG7KH
PHGLDLVFURVVFXWE\SUHVVLQJ>(17(5@NH\
(Media Feed)
.......... The label material (media) is fed as long as you hold down this key in the READY screen.
:KHQ>(17(5@NH\LVSUHVVHGDWWKHVDPHWLPHLQWKLVVWDWXVWKHPHGLDFRQWLQXHVWR
HYHQLI\RXUHOHDVHWKHNH\3UHVVLQJ>
@NH\DJDLQVWRSVWKHPHGLDIHHG
POSITION ( , , , ) Key
............................ Adjust various settings, select numerical value changes, move the cursor, and change
positions.
ENTER ....................... $IWHUVHWWLQJDIXQFWLRQRUFRQGLWLRQDWWKHFRQWUROSDQHOSUHVVWKH>(17(5@NH\WR
register your setting.
ESC ............................ Cancel setting change and return to the previous screen in the menu. Return to the
previous screen in the menu.
When this key is pressed during operation, 1 page of the cutting side at the time that the
key is pressed is cut and then the operation is stopped.