GRAPHTEC LABERLROBO DLC1000 - Setting the Acceleration

2-64
Setting the Acceleration
Set the acceleration of the tool that is used in each of the tool condition numbers.
Setting range: 1 to 3
Operation
1
3UHVVWKH>&21'7(67@NH\LQ5($'<VWDWXV
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION ( ) keys to select the CUT
CONDITION (The selected item is highlighted.). Then, press
>(17(5@NH\
Cond No. selection screen is displayed.
3
Press the POSITION ( ) keys to select the ACCEL.
Supplement
Settable range is 1 to 3.
When the value is reduced, the acceleration is
lower and the quality is better.
4
Press the POSITION ( ) keys to increase or decrease the
setting value.
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
Setting will be set, and it will return to CUT CONDITION & TEST screen.
6
3UHVVWKH>(6&@NH\
It will return to READY screen.