GRAPHTEC LABERLROBO DLC1000 - 2.7 Using Laminate Material

2-40
2.7
Using the Laminate
This chapter provides how to use a laminate.
Set the laminate after setting the label material.
Supplement
•
Please set the laminate after setting the label material.
•
For the setting of label material, please refer to "2.5 Setting the Label Material (Media)".
•
When the glue of laminate material is adhered to the push roller, it may affect the cutting accuracy. Please clean periodically the
push roller.
•
7KHODPLQDWHKROGHUÁDQJHLVVLPLODUWRWKHUROOKROGHUÁDQJH6PDOOHUÁDQJHLVDODPLQDWHKROGHUÁDQJH
•
The shape of laminate winder bobbin is similar to those of separator winding bobbin. The bobbin that is not marked (groove) on the
VHSDUDWRUÁDQJHFROODULVDODPLQDWHZLQGHUEREELQ
•
When the laminate is not used, please remove the laminate winding bobbin.
•
Paper core for winding is sold separately.
<Media Path>
Press roller
Cutter unit
Separator suppression unit
(Brush part)
Separator unit (Weeding)
Separator winder bobbin
Cross cutter
Slitter
Ejection roller
Dancer roller 1
Laminate winder bobbin
Laminate holder
Dancer roller 2
Roll holder
Roll holder
www.delinit.by