GRAPHTEC LABERLROBO DLC1000 - DHCP Settings

5-4
DHCP settings
7KH'+&3VHWWLQJVGHSHQGRQWKHFRQÀJXUDWLRQRIQHWZRUNHTXLSPHQWDQG\RXUHQYLURQPHQW)RUGHWDLOVUHIHUWR
your equipment manual or consult your network administrator.
The default setting of the DHCP is “Off”.
Operation
1
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
2
Press the POSITION ( ) keys to select the I/F (LAN) (The
VHOHFWHGLWHPLVKLJKOLJKWHG7KHQSUHVV>(17(5@NH\
I/F(LAN) screen is displayed.
Supplement
The current DHCP settings are displayed on the
right side of the "DHCP" screen.
3
Press the POSITION ( ) keys to select the DHCP.
7KHQSUHVV>(17(5@NH\
DHCP screen is displayed.
Supplement
3UHVVLQJWKH>(6&@NH\12UHWXUQVWRSUHYLRXV
screen without changing the settings.
4
Press the POSITION ( ) keys to select “ON” (enabled) or
“OFF” (disabled).
(When the DHCP is set to “ON” (enabled), it takes time to
reset)
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
I/F(LAN) screen is displayed.
6
3UHVVWKH>0(18@NH\
It will return to READY screen.