GRAPHTEC LABERLROBO DLC1000 - 2.10 COND;TEST Key Function

2-55
2.10
COND/TEST Key
7RVHWWKHFXWWLQJFRQGLWLRQVDQGFRQÀUPWKHFXWWHVWDQGWKHFXWWLQJDUHDZLGWKSUHVVWKH&21'7(67NH\LQ
the READY screen.
CUT CONDITION: Set the tool conditions, cross cut, rewind to cut the media.
CUT TEST: Perform the cut test.
TANGENTIAL MODE: Set Tangential Mode (thick media).
CUTTING WIDTH: Display the cutting area (width).
Screen Flow Through COND/TEST Key
>&21'7(67@
> @
>(17(5@
> @
>(17(5@×2
> @
>(17(5@×3
>(17(5@
Operation
1
3UHVVWKH>&21'7(67@NH\LQ5($'<VWDWXV
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION ( ) keys to select the item in the screen
above as necessary (The selected item is highlighted.). Then,
SUHVV>(17(5@NH\