GRAPHTEC LABERLROBO DLC1000 - 2.13 Running Cutting Tests

2-72
2.13
Running Cutting Tests
Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the
selected cutting conditions actually produce the desired cutting results.
Check how far the blade cuts into the media and how the corners are being cut.
If the cutting results are not satisfactory, adjust the various settings and repeat the test cutting until the optimal
settings are achieved.
Cutting Test
Here, you can either cut one test pattern based on the current values, or do Four tests with ±1 values added.
To make 1 cut with set value (CUT TEST : BASIC)
Operation
1
Load the media for test cutting in the machine.
2
3UHVVWKH>&21'7(67@NH\LQ5($'<VWDWXV
CUT CONDITION & TEST screen is displayed.
3
Press the POSITION ( ) keys to select the CUT TEST (The
VHOHFWHGLWHPLVKLJKOLJKWHG7KHQSUHVV>(17(5@NH\
CUT TEST selection screen is displayed.
4
Press the POSITION ( ) keys to select the BASIC.
5
3UHVV>(17(5@NH\