4-21
If the bar code does not match
When “BAR CODE” is set to "ENABLE" and the machine reads in the printed bar code with the sensor in the
cutter unit and then the code does not match with the code stored in the transferred data, the cutting operation is
suspended and a key input is requested after the following message (W10) is displayed.
>(6&@
>(17(5@
>(17(5@
(1$%/(!>(17(5@
>(6&@
Change to <DISABLE>
>(17(5@
>(17(5@
>(6&@
(Even when the code is different.)
The cutting operation is performed continuously.
To Next Page
Loading...
