GRAPHTEC LABERLROBO DLC1000 - Setting the Force

2-63
Setting the Force
Set the cutting force that is used in each of the condition numbers.
Setting range: 1 to 31
Operation
1
3UHVVWKH>&21'7(67@NH\LQ5($'<VWDWXV
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION ( ) keys to select the CUT
CONDITION (The selected item is highlighted.). Then, press
>(17(5@NH\
Cond No. selection screen is displayed.
3
Press the POSITION ( ) keys to select the FORCE.
Supplement
Settable range is 1 to 31.
4
Press the POSITION ( ) keys to increase or decrease the
setting value.
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
Setting will be set, and it will return to CUT CONDITION & TEST screen.
6
3UHVVWKH>(6&@NH\
It will return to READY screen.