GRAPHTEC LABERLROBO DLC1000 - When the Winding Roll Holder Is Not Used

2-35
<When the winding roll holder is not used>
1
Feed the media after pulling out about 20 cm.
CAUTION
When the winding roll holder is not used, since the media stays there, the cut media might be folded or creased.
Typically the media must be wound using the winding roll holder.
17
Set the roll holder in the winding stocker.
Close the winding stocker cover.
* When the media to be wound is one set, use the upper roll holder.
Roller
Roller
Set the roll holder so that the
grooves contact the receiving roller.
Winding stocker cover
Set the roll holder between
the rollers.