GRAPHTEC LABERLROBO DLC1000 - 4.15 Length Unit Setting

4-27
4.16
LENGTH UNIT
Set the display length unit from the “LENGTH UNIT”.
The display unit in coordinate values indicated on the display can be switched from/to millimeters to/from
inches.
The switched length unit is reflected in the items of position adjustment and numeric entry of registration
mark. Other units are fixed in the meter-based unit.
Operation
1
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
2
Press the POSITION ( ) keys to select “CHANGE
SETTINGS” (The item is highlighted.). Then, press
>(17(5@NH\
CHANGE SETTINGS screen is displayed.
3
Press the POSITION ( ) keys to select “LENGTH
81,7µ7KHQSUHVV>(17(5@NH\
LENGTH UNIT screen is displayed.
Supplement
3UHVVLQJ>(6&@NH\12UHWXUQVWRSUHYLRXV
screen without changing the settings.
4
Press the POSITION ( ) keys to select either “mm”
or “inch”.
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
Setting will be set, and it will return to CHANGE SETTINGS.
6
3UHVVWKH>0(18@NH\
It will return to READY screen.