GRAPHTEC LABERLROBO DLC1000 - Setting the Tool

2-60
Setting the Tool
Set the tool to be used. Set it in accordance with the guidelines on the tool conditions of label material and tool
type. (Refer to “Setting Tool Condition” described above.)
Tool type: “CB09U” and “CB15U”
Operation
1
3UHVVWKH>&21'7(67@NH\LQ5($'<VWDWXV
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION ( ) keys to select the CUT
CONDITION (The selected item is highlighted.). Then, press
>(17(5@NH\
Cond No. selection screen is displayed.
3
Press the POSITION ( ) keys to select the tool.
Supplement
3UHVVLQJWKH>(6&@NH\12UHWXUQVWRWKH&87
CONDITION & TEST screen without changing
the settings.
4
Press the POSITION ( ) keys to set the tool.
Settable tools are “CB09U” and “CB15U”.
5
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\
Setting will be set, and it will return to CUT CONDITION & TEST screen.
6
3UHVVWKH>(6&@NH\
It will return to READY screen.