GRAPHTEC LABERLROBO DLC1000 - Page 39

2-13
2
/RRVHQWKHÁDQJHÀ[LQJVFUHZRIWKHUROOKROGHUE\WXUQLQJLWFRXQWHUFORFNZLVH
Remove the ÁDnge.
,IWKHÁDQJHÀ[LQJVFUHZVWRXFKHVWKHSLQRIVKDIWSOHDVHORRVHQWKHÁDQJHÀ[LQJVFUHZVXQWLOLWFDQQRW
be touched.
)ODQJHÀ[LQJVFUHZ
)ODQJHÀ[LQJVFUHZ
Roll holder shaft
Flange B
Flange A
Pin
3
$WWDFKWKH)ODQJH%WRWKHUROOKROGHUVKDIW6HWLQWKHGLUHFWLRQÁDQJHÀ[LQJVFUHZVVLGHLQZKLFKWKHUH
is a pin of the shaft.
)ODQJHÀ[LQJVFUHZ
Pin
Shaft
Flange B
Insert the Flange B until it stops with a screw.
7LJKWHQWKHÁDQJHÀ[LQJVFUHZVWHPSRUDULO\WLJKWHQ
)ODQJHÀ[LQJVFUHZ
(temporarily tighten)
Screw
Flange B