GRAPHTEC LABERLROBO DLC1000 - Page 110

3-6
6HWWLQJWKHYHFWRUL]DWLRQ
of raster line.......... 2QO\ZKHQWKHYHFWRUL]DWLRQRIUDVWHUOLQHLVVHWWR´3URFHVVµ\RXFDQVHWWKH
YHFWRUL]DWLRQ
3HUIRUPÀQH
OLQHYHFWRUL]LQJ ..... 9HFWRUL]LQJLVSHUIRUPHGDIWHUWKHGDWDKDVEHHQFRQYHUWHGWRÀQH
lines.
,IWKHOLQHVWREHYHFWRUL]HGDUHWRRZLGHWKHGULYHUZLOOQRWUHFRJQL]H
them as Cutlines and they will not be output. If you want to output
such lines as Cutlines, check this box.
8VHWKLVRSWLRQZLWKDSSOLFDWLRQVZKHUHÀQHOLQHVFDQQRWEHRXWSXW
Line Length ..........6SHFLÀHVWKHPLQLPXPOHQJWKRIWKHFXWOLQHVWREHRXWSXW
The driver ignores lines which are shorter than this length, and does
not output them.
The settings range is 0.1 mm - 5.0 mm.
Treat as same
line if gap is .......... 6SHFLÀHVWKHGRWJDSZKLFKLVDFFHSWDEOHDVVDPHOLQHGDWD
Depending on the application used, gaps can occur in an output
UDVWHUOLQHPDNLQJLWGLIÀFXOWWRGHWHUPLQHZKHWKHUWKHVHJPHQWVDUH
IURPWKHVDPHOLQHRUVHSDUDWHOLQHV7KLVRSWLRQÀOOVLQWKHGRWVDQG
enables output as one continuous line. However, if this value is too
large, separate lines may be treated as one continuous line.
The settings range is 0 to 20 dots.
Previewing
the cut line ............ Used to select whether or not to preview the cut line.
<RXFDQFRQÀUPWKHSUHVHQFHRUDEVHQFHRIWKHFXWOLQH
,IVHWWLQJRXWSXWSRUWWRÀOHWKHFXWOLQHLVQRWGLVSOD\HG
Restore Defaults ......... Restores the set value to the initial value.