GRAPHTEC LABERLROBO DLC1000 - Page 162

I-2
P
Panel Keys .................................. 2-6
PAPER-WEIGHT .............................. 4-17
POSITION Key ............................... 2-6
Power cable .............................. 1-2, 2-10
Power switch .............................. 1-4, 2-9
Press roller .................................. 1-3
Press roller lever ...................... 1-3, 2-20, 2-37
Push roller ................................... 1-6
R
Reading the Screen (LCD) ...................... 2-7
READY .................................. 2-7, 4-2
READY Lamp ................................ 2-6
READY screen ............................... 2-7
READY Screen ............................... 4-2
Removing the tool ............................. 2-5
REWIND ................................... 2-66
Roller position guides ......................... 2-39
Roll holder ..................... 1-2, 1-3, 1-4, 2-12, 2-32
Roll stocker cover ......................... 1-3, 2-12
S
Safety Precautions .............................. ii
SEARCH START-MARK ........................ 4-8
Select the Tool Conditions ..................... 2-56
SENSING SPEED ............................. 4-12
SENSOR OFFSET ADJUST ..................... 4-14
6HSDUDWRUÁDQJHFROODU ................. 1-2, 2-26, 2-45
Separator suppression unit .............. 1-3, 2-20, 2-23
Separator unit ............................ 1-4, 2-25
Separator winder bobbin ................. 1-2, 1-3, 2-26
Set lever ......................... 1-3, 1-6, 2-20, 2-37
SETTING INTERFACE ......................... 5-2
Setting the Acceleration ....................... 2-64
Setting the Cross Cut ......................... 2-65
Setting the Force ............................. 2-63
Setting the Label Material (Media) ................ 2-11
Setting the Length of Overcuts .................. 2-68
Setting the Media ............................. 2-11
Setting the Offset ............................ 2-61
Setting the Rewind ........................... 2-66
Setting the Speed ............................ 2-62
Setting the Tangential Emulation ................ 2-67
Setting the Tool .............................. 2-60
Setting Tool Condition ......................... 2-58
Shaft ........................... 1-2, 2-13, 2-32, 2-41
Slitter .................................. 2-29, 2-51
Slitter unit ................................... 1-4
Speed ..................................... 2-62
Stand ....................................... 1-4
Structure of Cutter Plunger ...................... 2-2
Subnet mask setting ........................... 5-6
Supplies Accessories .......................... A-4
T
TANGENTIAL MODE ......................... 2-67
TO ENSURE SAFE AND CORRECT USE ............ i
Tool ....................................... 2-60
Tool carriage ................................. 1-6
Tool holder ................................ 1-6, 2-4
Turning on the Power .......................... 2-9
U
USB interface ................................ 1-3
USB Interface ................................ 5-2
User's Manual ................................ 1-2
Using the Cross Cutter ........................ 2-48
Using the Laminate ........................... 2-40
Using the Slitter .............................. 2-49
W
Warning Messages ............................ 6-7
Winding stocker cover ...................... 1-4, 2-32