GRAPHTEC LABERLROBO DLC1000 - Page 47

2-21
< Media Path >
Press roller
Cutter unit
Separator suppression unit
(Brush part)
Separator unit (Weeding)
Separator winder bobbin
Cross cutter
Slitter
Ejection roller
Dancer roller 1
Laminate winder bobbin
Laminate holder
Dancer roller 2
Roll holder
Roll holder
2
Pull out the media in a state which the media is set in the roll stocker.
Insert the media into the machine.
*
If the media is strongly curled, fold (valley fold) at about 5 to 10 cm from the tip of media and then insert it.
Fold (valley fold)