2-31
Supplement
When the set lever of cutter unit is lowered, or
when the material is not fed to the cutter unit,
the same message is displayed.
13
Turn on ("|" side) the power of the machine.
The following screen is displayed.
14
)HHGWKHPHGLDE\SUHVVLQJ> @NH\Media Feed).
Pull out the media about 30 cm backward from the slitter.
Then tighten the screw of slitter.
Screw
15
Pull out the media from the slitter backward.
When the winding roll holder is used, pull out about 60 cm.
When the winding roll holder is not used, pull out about 20 cm.
When the winding roll holder is not used
Approx. 20 cm Approx. 60 cm
When the winding roll holder is used
To Next Page
Loading...
