GRAPHTEC LABERLROBO DLC1000 - Page 59

2-33
2
Attach the Flange B to the roll holder shaft.
6HWLQWKHGLUHFWLRQÁDQJHÀ[LQJVFUHZVVLGHLQZKLFKWKHUHLVDSLQRIWKHVKDIW
)ODQJHÀ[LQJVFUHZ
Pin
Shaft
Flange B
Set the Flange B at the position where it stops with the screw.
7LJKWHQWKHÁDQJHÀ[LQJVFUHZVWHPSRUDULO\WLJKWHQ
)ODQJHÀ[LQJVFUHZ
(temporarily tighten)
Screw
Flange B
* When winding the media which the edge is cut by the slitter, set the media after aligning the
Flange B to the position of line.
)ODQJHÀ[LQJVFUHZ
(temporarily tighten)
Flange B
Line