GRAPHTEC LABERLROBO DLC1000 - Page 79

2-53
4
)HHGWKHPHGLDFDUHIXOO\ZKLOHSUHVVLQJ> @NH\0HGLD)HHG
Pull out the media about 30 cm backward from the slitter.
Tighten the screw of the slitter.
Screw
Cross cutter
Slitter
Media Path
CAUTION
Please be careful there is no slack in the media between the cross cutter and slitter.
The media might not be able to successfully feed when there is slack.
Slack
•
When there is slack in the media
 2SHQWKHVHWOHYHURIFXWWHUXQLWDQGHMHFWLRQUROOHUOHYHUDQGWKHQIHHGWKHPHGLDE\SUHVVLQJ>
@NH\)(('
It is possible to eliminate the slack by feeding the media in the slitter.