MALFUNCTION INSPECTION CU800 Service Manual
134
5.2.4 Checking Steering Column
1. Check:
• steering column tube ①
• bearing ②
• central axis of the steering shaft ③
• spline ④
• loosening ⑤
• rocky ledge ⑥
If the central axis of the steering shaft is
flexible or moves, dismantle and check the axis,
bearing and retaining ring whether ware or
damaged, according to the inspection situation
to instead the parts.
2. Check:
Whether two ends of the spline on central axis is wear out, if so, replace the central axis.
3. Check:
Whether the spline at two ends of the central axis have worn, if so, replace the central axis.
4. Check:
The steering shaft tube and welding line of the branch whether have crack and corrosion, if it does,
instead the steering shaft tube.
5.2.5 Disassembling Steering Drive Axle
1. Loose the clamp one piece flange bolt in the cross gimbal, internal spline on the top of the steering
drive axle, pull out the top of the steering drive axle.
2. Loose the clamp one piece flange bolt in the cross gimbal, spline on the bottom of the steering
drive axle, pull out the lower of the steering drive axle.
To Next Page
Loading...
