12
lldp tlv-enable { basic-tlv { all | port-description |
system-capability | system-description | system-name |
management-address-tlv [ ipv6 ] [ ip-address ] } | dot1-tlv { all |
link-aggregation } | dot3-tlv { all | link-aggregation | mac-physic |
max-frame-size | power } | med-tlv { all | capability | inventory |
power-over-ethernet | location-id { civic-address device-type
country-code {
ca-type ca-value }&<1-10> | elin-address
tel-number } } }
By default, the nearest bridge agent advertises the following TLVs:
− Link aggregation TLVs in the 802.1 organizationally specific TLV set.
− All supported 802.3 organizationally specific TLVs.
− All supported LLDP-MED TLVs except the network policy TLVs.
lldp agent { nearest-nontpmr | nearest-customer } tlv-enable
{ basic-tlv { all | port-description | system-capability |
system-description | system-name | management-address-tlv [ ipv6 ]
[ ip-address ] } | dot1-tlv { all | link-aggregation } | dot3-tlv { all |
link-aggregation } }
By default:
− The nearest non-TPMR bridge agent does not advertise anyTLVs.
− The nearest customer bridge agent advertises all supported basic management TLVs
and link aggregation TLVs in the IEEE 802.1 organizationally specific TLV set.
{ In Layer 2 aggregate interface view:
lldp tlv-enable dot1-tlv { protocol-vlan-id [ vlan-id ] | vlan-name
[
vlan-id ] | management-vid [ mvlan-id ]
lldp agent nearest-nontpmr tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ] [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv
{ all | port-vlan-id } }
By default, the nearest non-TPMR bridge agent does not advertise any TLVs.
lldp agent nearest-customer tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ] [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv
{ all | port-vlan-id } }
By default, the nearest customer bridge agent advertises all supported basic management
TLVs and the following IEEE 802.1 organizationally specific TLVs:
− Port and protocol VLAN ID TLVs.
− VLAN name TLVs.
− Management VLAN ID TLVs.
The nearest bridge agent is not supported.
{ In Layer 3 aggregate interface view:
lldp agent { nearest-customer | nearest-nontpmr } tlv-enable
basic-tlv
{ all | management-address-tlv [ ipv6 ] [ ip-address ] |
port-description | system-capability | system-description |
system-name }
By default:
− The nearest non-TPMR bridge agent does not advertise any TLVs.
− The nearest customer bridge agent advertises all supported basic management TLVs.
The nearest bridge agent is not supported.
{ In IRF physical interface view:
To Next Page
Loading...
Need help?
General