H3C S6850 Series

11
country-code { ca-type ca-value }&<1-10> | elin-address
tel-number } } }
By default, the nearest bridge agent advertises all supported TLVs except the following
TLVs:
− DCBX TLVs.
− Location identification TLVs.
− Port and protocol VLAN ID TLVs.
− VLAN name TLVs.
− Management VLAN ID TLVs.
lldp agent nearest-nontpmr tlv-enable { basic-tlv { all |
port-description | system-capability | system-description |
system-name | management-address-tlv [ ipv6 ] [ ip-address ] } |
dot1-tlv { all | port-vlan-id | link-aggregation } | dot3-tlv { all |
link-aggregation } }
lldp tlv-enable
dot1-tlv { protocol-vlan-id [ vlan-id ] | vlan-name
[ vlan-id ] | management-vid [ mvlan-id ] }
By default, the nearest non-TPMR bridge agent does not advertise any TLVs.
lldp agent nearest-customer tlv-enable { basic-tlv { all |
port-description | system-capability | system-description |
system-name |
management-address-tlv [ ipv6 ] [ ip-address ] } |
dot1-tlv { all
| port-vlan-id | link-aggregation } | dot3-tlv { all
| link-aggregation } }
lldp tlv-enable
dot1-tlv { protocol-vlan-id [ vlan-id ] | vlan-name
[ vlan-id ] | management-vid [ mvlan-id ] }
By default, the nearest customer bridge agent advertises all the supported basic
management TLVs and IEEE 802.1 organizationally specific TLVs.
{ In Layer 3 Ethernet interface view:
lldp tlv-enable { basic-tlv { all | port-description |
system-capability | system-description | system-name |
management-address-tlv [ ipv6 ] [ ip-address | interface loopback
interface-number ] } | dot1-tlv { all | link-aggregation } | dot3-tlv
{ all | link-aggregation | mac-physic | max-frame-size | power } |
med-tlv { all | capability | inventory | power-over-ethernet |
location-id { civic-address device-type country-code { ca-type
ca-value }&<1-10> |
elin-address tel-number } } }
By default, the nearest bridge agent advertises the following TLVs:
− Link aggregation TLVs in the 802.1 organizationally specific TLV set.
− All supported 802.3 organizationally specific TLVs.
− All supported LLDP-MED TLVs except the network policy TLVs.
lldp agent { nearest-nontpmr | nearest-customer } tlv-enable
{ basic-tlv { all | port-description | system-capability |
system-description | system-name | management-address-tlv [ ipv6 ]
[ ip-address ] } | dot1-tlv { all | link-aggregation } | dot3-tlv { all |
link-aggregation } }
By default:
− The nearest non-TPMR bridge agent does not advertise any TLVs.
− The nearest customer bridge agent advertises all supported basic management TLVs
and link aggregation TLVs in the IEEE 802.1 organizationally specific TLV set.
{ In management Ethernet interface view: