2.7.1 Transport, setup, installation and disposal
Im
proper transport
Improper transport can cause the machine to tilt or fall. This can cause severe
crushing.
● Carry out transport according to the specifications in this instruction.
● Move unauthorised people out of the area.
● Always clean and tidy the work area and cordon it off.
● Ensure that there is room to escape should the machine fall.
● Only use suitable lifting gear that has a sufficient load-carrying capacity.
● Keep the machine's centre of gravity in consideration.
● Take measures to prevent the machine from slipping.
● Never lift loads over a person.
● Do not stop below suspended loads.
● Keep enough distance to the machine during transport.
● Transport the machine as carefully as possible.
● Chains, belts, ropes or other hoisting devices must be equipped with safety
hook
s.
● Do not use any torn, frayed or knotted chains, belts or ropes.
● Ensure that chains, belts and ropes do not lie against sharp edges.
Inc
orrect setup and installation
Serious injuries and material damage.
● Machine may only be set up by authorised, trained personnel who are
f
amiliar with how to operate the machine and are in strict observance of all
safety instructions.
● Before assembling and installing the machine, check to make sure it is com-
ple
te and in good condition.
● Only assemble and install the machine if the machine and all of the parts
ar
e complete and intact.
● Do not setup machine in areas with high electromagnetic fields.
● Do not setup machine on escape routes.
● Only place machine within buildings.
● Place the machine on a level, sufficiently stable, non-slip and vibration-free
sur
face.
● The load bearing capacity, the coating and the surface of the floor must not
be af
fected in the long term.
● The foundation must comply with the norms stipulated in the technical lay-
out
s.
● Ensure that sufficient lighting is available.
Insuf
ficient space - Approximation of a workpiece to a fixed object or building structure
The approximation of a workpiece to a fixed object or building structure can lead
to severe crushing of limbs as well as the entire body.
● Observe minimum distances to spatial boundaries.
● Ensure that there is sufficient space to work around the machine.
● Keep enough distance to moving workpieces.
● Keep enough distance to adjacent machines.
To Next Page
Loading...
Need help?
General
