Hammer A2-26 - Machine Cleaning Procedures

69
A2-26
Maintenance
Note
Cle
aning and care products are available as accessories (see:
Tools and accessories catalogue).
10.3 Clean the machine
NOTICE
Poor cleaning
Chips i
gnite, fire
− Regularly clean the machine of dust and chips.
1
2
3
4
5
6
Fig. 52: Overview - cleaning
1 Table surface - thicknesser table
2 Table surfaces - planer tables
3 Guiding surfaces - planer fence
4 Guiding surfaces - thicknesser table
5 Transport rollers and kickback guards
6 Space under the thicknesser table
Protective equipment:
● Protective clothing
● Protective gloves
● Safety goggles
T
ool:
● Cleaning cloths
● Resin remover
● Vacuum cleaner
1.
Switch off the machine and secure it against being switched on again.
2.
Clean the machine of dust, shavings, waste material and other contami-
nant
s.
3.
Clean the machine, table and guide surfaces or chips and dust.
4.
Clean the planing fence and the cutterblock cover and check for correct
func
tion.