Part 2: FlexColor for Cameras
Importing Camera Images
Click on Load to open the Load window. This window provides more
scope controls and enables you to establish the initial setup, name and
numbers for the imported image(s). See also “
Load Window Buttons and
Controls” on page 25 for details.
Double-click on an image to import that image and open it in the preview
window. (Or select an image and click on the Show button to do the same
thing.)
Drag one or more selected images from the Import window to the
Thumbnails window.
6. The images are loaded and convert them to 3F. They will be saved in your
current image folder, which is the one shown in your Thumbnails window.
Import Window Buttons and Controls
The controls of the Import window are similar to those of the Thumbnails window.
The following buttons and controls are provided:
Location: this pop-up menu, located at the top of the window, enables you to
select the folder from which you will import. The menu lists your most
recently used folders and enables you to add or remove favorite locations that
you use often. Select “Choose Location” to open a browse window with which
to navigate to and select a new folder.
Get Info: displays details about the currently selected image.
Delete: permanently deletes the currently selected image(s).
Show: imports the currently selected image into the currently active 3F folder
(this is also the folder currently shown in the Thumbnails window) and shows
opens the image into the preview window. This button is inactive when more
than one image is selected.
Load: opens the Load window, which enables you to apply filters and change
options as you import images. The 3F images will be saved in the currently
FlexColor 4.5 Documentation Addendum 24
To Next Page
Loading...
Need help?
General
