70
Modifying Selected Images
e umbnails window gives access to many different types of
information about each image. It provides settings that enable you to
modify the images by adding new setups to the history, selecting a default
setup, entering meta data and more.
You can make these settings in two ways: using the Info window
or by using the Modify window, each of which is available from the
umbnails window. e two windows provide slightly different
options; generally you will use the Info window to work with individual
images and the Modify window to modify several images at once, though
you might also sometimes use the Modify window for single images. e
Modify window and its settings are described in this section; for details
about the Info window, please see “e Info Window” on page 79.
Modifying the Setup and/or History
Each 3f file holds at least one setup, which is the setup used when the
file was first scanned. Each time you export from a 3f file, the setup used
for the export is added to the history. When more than one setup exists
in the history, one of them is designated as the default setup, which is
applied to the thumbnail and is loaded when the file is opened in the
main FlexColor window.
You can use the Modify window to add a new setup, modify an existing
setup and/or make your new setup the default. To do this:
To Next Page
Loading...
Need help?
General
