July 2010 13 – 191
Figure: Read-out file
Reading in data
using TNCremoNT
In the lower screen half (iTNC 530 contents), select the target drive and the target directory:
8 Click the bar with the drive information. --> Its color changes from gray to blue, and two
buttons appear at the right side in the bar.
8 Click the Change folder/drive... button. --> A new window opens.
8 Now, select the drive and the folder. --> The path is displayed in the blue bar.
In the upper screen half (laptop/PC contents), select the source drive and the source
directory:
8 Click the bar with the drive information. --> Its color changes from gray to blue, and two
buttons appear at the right side in the bar.
8 Click the Change folder/drive... button. --> A new window opens.
8 Now, select the drive and the folder. --> The path is displayed in the blue bar.
Transfer the data:
8 Using the mouse, click the directory you wish to read in.
8 Press and hold the left mouse button and pull the directory or the file into the lower window.
8 Release the mouse button. --> The file is being transferred.
During downloading the data format is automatically converted from BINARY (control) to
ASCII (laptop/PC) via TNCremoNT.
For changing to the PLC: und SYS: control partitions, the respective code numbers are
interrogated.
During uploading the data format is automatically converted from ASCII (laptop/PC) to
BINARY (control) via TNCremoNT.
To Next Page
Loading...
