25 – 416 HEIDENHAIN Service Manual iTNC 530
Touch probe cycles By means of touch probe cycles ...
Datums can be set in manual and automatic mode.
Workpiece misalignment can be compensated manually and automatically.
Workpieces can be measured automatically.
Tools can be measured automatically.
Touch probe systems can be calibrated.
Pin layout See “Touch Probes” on page 27 – 507.
Other
information
You will find further information on touch probes in …
The iTNC 530 User's Manual
The corresponding mounting instructions
The brochure 3-D Touch Probes for Machine Tools
These documents can be downloaded from the HEIDENHAIN website (www.heidenhain.de).
To Next Page
Loading...
